The Hot Air Stenter （ https://www.hotairstenter.com/product/hot-air-stenter.html ） is mainly used for embossing, foaming, creasing, and trademarking on various fabrics, as well as embossing trademarks on non-woven fabrics, coatings, human leather, paper, aluminum plates, artificial leather patterns and various Deep shades and patterns.

(1) Before working, first check the switches that control the rise of the workbench, and check whether the safety shutters and emergency stop switches are effective.

(2) When using the embossing board, pay attention to that the pattern must be clean and clear. In case of contamination, the corresponding organic solvent and fine copper wire brush should be used for scrubbing. If possible, use high-pressure water gun and hot water for flushing. When cleaning the flower plate, remove the flower plate from the machine and find a place with good ventilation away from fire and flammable materials.

(3) According to the temperature required by the production process, heat the embossed plate half an hour in advance. Check whether the temperatures in the three temperature zones are consistent.

(4) Install the required embossing board (or screed) according to the production process requirements. Before installing the board, all the pressing plates that fix the embossing board (or screed) should be removed, and they should not be hung on the bolts to avoid embossing. The board (or screed) is crushed. The working pressure when changing the trigger cannot be adjusted too high.

(5) Pay attention to safety during the plate changing process. Before ascending the workbench, inform other personnel involved in the work, and make sure that all personnel's limbs have left the workbench. There are no other objects on the embossing board or screed. Before using the forklift, first check the working condition of the forklift, if any abnormality must be repaired, so as not to cause personal injury or damage to the embossing plate and screed during the plate replacement process.

(6) No items other than leather sheets should be placed on the workbench, except for felt pads and rubber plates required for work.

(7) Wear long-sleeved overalls and tighten cufflinks or sleeves when working, do not wear jewelry such as rings, bracelets, bracelets, etc., do not cut nails too short, and do not touch heated embossing plates or screeds. When using the mobile phone, leave the working area of ​​the Open Type Rotary Screen Printer （ https://www.hotairstenter.com/product/ ）.