You should use this-it-yourself test before calling an expensive waterproofing contractor to check if there is any other problem with your water leak than poor waterproofing.

Fill the gutter, blowouts, inspect and fill. In the longer term, the strongest drainage roof systems can be covered, or waterproofing troughs can cover seams. Remove any leaves or dust from all ribs to test the device.

Then use a pants for at least 5-10 minutes to spray along the troughs and drains to ensure proper drainage of water.

Foundation Test the surface slope and property. Make sure that water flows from the building at least 48 "and 60." If the water is not drying out, it can be taken home and rushed back into it.

Leaks Check for leaky pipes under your sinks, toilets, etc. Use a flashlight to map all rivers in the building's basement or crawl area. Test the pipes as they enter the house. Remove some soil or stone to look for drop. If required, fix any waterproofing structures.

Supply lines Look for leaks on the water supply lines along the joints. Over time, water pipes can rot or deteriorate, and freezing cold may affect waterproofing around fittings and elbows. Turn all the water in your room to check for leaks. Write your heat meter. Wait 30-60 minutes, read the meter again. If the meter adjusted, you have an undetected leak. You don't need a waterproofing expert to leak.

Floor Check for waterproofing in your basement walls. The easy way to do this is to take a 12 "piece of aluminum foil and smooth it over the surface of the suspect wall. Seal the edges shut. Just wait a day or two to check the foil. If the foil is wet, the result is a condensation when it is warm indoors and it comes from filtering. For more information please visit http://www.flexcontracting.com