Petrol Log Splitter ( https://www.cnsuperpower.com/product/log-splitter/ ) is a special equipment for preparing high-quality wood chips. It is suitable for paper mills, particle board plants, fiberboard plants and wood chip production bases. It can cut logs, small diameter wood, etc. into high-quality industrial wood chips with uniform length, flat cuts and uniform thickness, and can also cut ya wood, boards, etc. What are the precautions during the use of Petrol Log Splitter?

　　 Precautions when using Petrol Log Splitter:

　　 1. The material should be pre-processed before cutting, such as bumping, winnowing, etc., and cutting after confirming that hard objects such as sand, stones, iron, etc. have been removed.

　　2. If abnormal noise occurs during operation, stop immediately and work again after troubleshooting.

　　 3. If there is friction between the turntable and the outer ring, loosen the outer ring fixing nut to adjust the gap between the turntable and the outer ring, so that the turntable can run freely.

　　4. If the turntable gets stuck in an accident, shut down immediately. Open the hopper cover, remove the turntable cover, beat the turntable to push the material block with wood to rotate it, and take out the foreign objects.

　　5. If there are burrs on the inner wall of the outer ring, remove the outer ring and sand it smoothly and smoothly.

　　 When the Performance Built Log Splitter is working, it must be noted that the temperature of the rolling bearing of the main shaft must not exceed 65°C. If it exceeds 65°C, the oil should be changed immediately. If it is still ineffective, the bearing should be removed and cleaned with kerosene, coated with lubricating oil, and then start working. Performance Built Log Splitter purchases equipment according to its own needs.

　　For your safety, please read the maintenance precautions of Performance Built Log Splitter ( https://www.cnsuperpower.com/product/log-splitter/ ):

　　 1. Pay attention to rust prevention, and the motor must not be damp, and no water may enter to prevent the machine parts from rusting.

　　 2. Before each start of the whole machine, fill each lubrication point with oil, and check whether each firm bolt is loose.

　　3, pay attention to the safety of electricity, wire strictly according to the requirements of the motor label, and connect the ground wire.

　　4. Feeding port and cutting room are forbidden to draw metal and debris. If any abnormality is found, turn off the power immediately.

　　 If the Performance Built Log Splitter blade becomes dull or chipped, 4 pieces should be ground at the same time to ensure the balance of the cutter head after installation, and the bed knife should be replaced in time when it becomes dull, otherwise the chip quality will be seriously affected.